Even a dummy load gets out somewhere! It's the SWR between the transmitter and the tuner that is changed with the tuner controls. You just learned how to hook it all up!
Be gentle to your radio; keep the key-down periods as short as possible. The interface cable is included. If you have high loses and a poor excuse for an antenna, you will have a poor excuse for a good signal no matter how well your tuner "tricks" your radio. Your rig "thinks" it's seeing a 50 ohm antenna on it's output! It can be operated via the panel of Kenwood transceivers.
Results 1 - 24 of 66 Match your transmitter or transceiver to virtually any antenna—balanced, unbalanced, or single-wire! Shop automatic and manual tuners. Results 1 - 24 of 68 Match your transmitter or transceiver to virtually any antenna—balanced, unbalanced, or single-wire! Shop automatic and manual tuners.
MFJ Manual Tuners
Many ham transmitters and transceivers, and virtually all amplifiers, output well over watts. A must have for all hams who need more information! Your transmitter will not know that you are trying to "load up" those old rusty bed springs or that poor excuse for an antenna!
Show only see all. Item location see all. Depending on the impedance at the antenna input and the overall design of the tuner you may not be able to obtain a flat 1: It can work within the range of 3MHz to 54MHz. Can be used as a band-pass filter, the emission can reduce unnecessary radiation outside the band, the cross-modulation and interference-band receiver can be reduced again. The more efficient your antenna system
Small young slavesex pics an antenna tuner or transmatch does do, however, is transform the impedance at the antenna feed output at the radio to a value that your transceiver can handle, typically 50 Ohms. When thinking about Amateur antenna tuners tuners and SWR, it's important to remember that the tuner has no effect whatsoever on the SWR between itself and the antenna. It's the SWR between the transmitter and the tuner that is changed Amateur antenna tuners the tuner controls. In layman's terms, all a tuner Amateur antenna tuners is act as a kind of adjustable impedance transformer between the radio and the antenna. It takes whatever impedance the antenna system presents, up to the design limits of the tuner, and attempts to convert it back to 50 Ohms--or something reasonably close to that value for the transceiver. When the transceiver "sees" a 50 Ohm impedance, it is able to load or produce it's maximum designed RF output into the system because it is designed to operate into a 50 ohm load. Your rig "thinks" it's seeing a 50 ohm antenna on it's Amateur antenna tuners